Welding

[84CoupeGT]

Evening all

I'm in the process of trying to get my Coupe GT back on the road. I'm not doing a full resto at the moment, just trying to get the car solid, protected and roadworthy for an MOT.

The car has a few bits of welding needed, the main areas being a hole in the off side rear wheel arch near where it meets the sill, two small holes in the off side A-pillar near the lower door hinge, small hole in near side outer sill, small hole in near side front wheel arch, off side front jacking point, and both sides of the front slam panel.

The car is in North Wiltshire near Swindon, so I'm looking for someone not too far away ideally but would consider a bit further afield.

Any recommendations very welcome and also any thoughts on what people think a reasonable estimate might be, would be much appreciated.

I will get round to posting up progress made so far on a readers resto soon!

Cheers,
Mark