7A Stroker project near complete

simons2 · 08-02-18, 01:01 PM

OK something alittle special for someone wanting a challenge.

7a block, diesel 95.5 crank, TSR big valve head, 7a rifle drilled rods, pistons from SA machined to suit, new rings, shells, HG. This will give you roughly 200BHP in a NA set up. 2.5Lt displacemet but will look OEM monster torque.
I'll include a few other bits I have kicking around to get you on your way..
£600

Please only get in touch if your serious

vorsprung durch technik · 08-02-18, 03:22 PM

Bargain!! Glws.

steve briance · 13-02-18, 06:08 PM

Big valve 7A head by TSR?

details?!

simons2 · 14-02-18, 07:34 AM

No 10v TSR big valve head to keep the original look.

msh · 14-02-18, 10:36 AM

In that case calling it "7A stroker" is misleading and it should be called "NG stroker" or "KV stroker", depending on head and intake manifold used, as there are no 7A specific parts remaining

simons2 · 14-02-18, 10:54 AM

OK keep your pants on

, it was a genuine advert. As the cost of a 7a head would be £400+ nowadays I would guess anyone genuinely interested would ask unless there a chancer

14-02-18, 10:54 AM	#6
simons2 Grown up member Classic Audi Club Member Join Date: Jun 2012 Location: ireland Posts: 291	OK keep your pants on, it was a genuine advert. As the cost of a 7a head would be £400+ nowadays I would guess anyone genuinely interested would ask unless there a chancer

08-02-18, 03:22 PM	#2
vorsprung durch technik 4 ring whore! Classic Audi Club Member Join Date: Feb 2014 Location: Near Watford. Posts: 7,753	Bargain!! Glws.

13-02-18, 06:08 PM	#3
steve briance Newbie! Join Date: Oct 2016 Posts: 18	Big valve 7A head by TSR? details?!

14-02-18, 07:34 AM	#4
simons2 Grown up member Classic Audi Club Member Join Date: Jun 2012 Location: ireland Posts: 291	No 10v TSR big valve head to keep the original look.

14-02-18, 10:36 AM	#5
msh 4 ring whore! Join Date: Jun 2008 Location: Rucava, Latvija Posts: 3,816	In that case calling it "7A stroker" is misleading and it should be called "NG stroker" or "KV stroker", depending on head and intake manifold used, as there are no 7A specific parts remaining