83 GT Rear Bumper end cap

Malcolmrs2000 · 17-04-23, 06:58 PM

Took the rear bumper off the car to polish behind it ( sad I know) put the bumper in the garage out of the way but the small end cap had come off…put it down beside the bumper…did others bits and pieces…..went to put it back on and the small end cap has gone walkies!!

Does anyone have one lying around.???..offside

Pretty please!!

84CoupeGT · 17-04-23, 07:33 PM

I've been looking for one of those since I've had my Coupe GT (almost 3 years!). Can't find one anywhere unless you buy a whole bumper. If I were you I'd have a real good look in that garage!!

Malcolmrs2000 · 18-04-23, 12:11 PM

Found it lurking behind the wheel of my RS2000…I reckon a passing haggis tried to steal it and dropped it and flew off!!!��

Surely there must be a member who has a 3D printer and can recreationte these parts??

84CoupeGT · 18-04-23, 02:58 PM

Phew! That was lucky!

I don't know much about 3d printing... It seems quite a complicated shape but it would be fantastic if someone could recreate it. Not sure how economical it would be, so few pre facelift cars about now and I don't think that part is shared with other Audis/VWs?

BackintheFold · 18-04-23, 03:26 PM

What is the part number please?

Malcolmrs2000 · 18-04-23, 05:11 PM

855807488

18-04-23, 03:26 PM	#5
BackintheFold Senior Member Classic Audi Club Member Join Date: Feb 2019 Location: Near an MB ur Quattro Posts: 1,190	What is the part number please? __________________ 2006 A3 (daily drive) 1987 MB ur

17-04-23, 07:33 PM	#2
84CoupeGT Grown up member Join Date: Nov 2020 Posts: 309	I've been looking for one of those since I've had my Coupe GT (almost 3 years!). Can't find one anywhere unless you buy a whole bumper. If I were you I'd have a real good look in that garage!!

18-04-23, 12:11 PM	#3
Malcolmrs2000 Grown up member Join Date: Apr 2021 Posts: 46	Found it lurking behind the wheel of my RS2000…I reckon a passing haggis tried to steal it and dropped it and flew off!!!�� Surely there must be a member who has a 3D printer and can recreationte these parts??

18-04-23, 02:58 PM	#4
84CoupeGT Grown up member Join Date: Nov 2020 Posts: 309	Phew! That was lucky! I don't know much about 3d printing... It seems quite a complicated shape but it would be fantastic if someone could recreate it. Not sure how economical it would be, so few pre facelift cars about now and I don't think that part is shared with other Audis/VWs?

18-04-23, 05:11 PM	#6
Malcolmrs2000 Grown up member Join Date: Apr 2021 Posts: 46	855807488