would these fit?

harmeetjohal · 20-08-09, 09:32 AM

Hi all I have seen some 16x8 rim’s with the following setup
OE SIZE BOLT LUG NUT CB ET
15 X 6 5X114.3 12mmX1.5 60.1 H

Can I get them to fit on a Audi 80
OE SIZE BOLT LUG NUT CB ET
14 X 6 4X108 14mmX1.5b 57.1 H

Would I need spacers? Redrill or adaptors?

Save Ferris · 20-08-09, 05:03 PM

You would need adaptors.

These wheels are 5 stud, your car is a 4 stud.

So yes, you could get them fit, but it would take some effort.

Coxy · 21-08-09, 06:34 AM

looking at them it would be a lot of hassle.

Different size centre bores (not buy much though, but by enough!) and then if you were to get some adaptors machined up, you'll have to remember to add about 25mm to the offset to allow for the thickness of the adaptors.
Could get the hubs redrilled but again, it's a lot of hassle.
Given the fact that there are a good variety of rims available in 4 x 108, they'd have to be bloody nice to want to go to all that trouble to get them on.

20-08-09, 05:03 PM	#2
Save Ferris Grown up member Join Date: Feb 2009 Location: Petersfield, Hampshire Posts: 94	You would need adaptors. These wheels are 5 stud, your car is a 4 stud. So yes, you could get them fit, but it would take some effort.

21-08-09, 06:34 AM	#3
Coxy 4 Ring Mafia Classic Audi Club Member Join Date: Jul 2007 Location: on the side of a hill in Shropshire! Posts: 28,215	looking at them it would be a lot of hassle. Different size centre bores (not buy much though, but by enough!) and then if you were to get some adaptors machined up, you'll have to remember to add about 25mm to the offset to allow for the thickness of the adaptors. Could get the hubs redrilled but again, it's a lot of hassle. Given the fact that there are a good variety of rims available in 4 x 108, they'd have to be bloody nice to want to go to all that trouble to get them on.