Quote:
Originally Posted by billy_bunter
As suggested on another forum I went into Pirtek with a few offcuts and what sizes I needed. They were really helpful. I came out with a some double sided barbed pipe joiners and hose clamps.
Hose clamps
https://www.ebay.co.uk/itm/Double-Ea...9vA:rk:12:pf:0
I then sourced 3 odd meters of fuel pipe from VW heritage. Along with some jubilee clips this enabled me to join the feed pipe using a joiner to the petrol pump to evaporator to carb. Then a pipe jubilee clipped to the return. I do not have the pressure problems you have as I run a carb! If I remember I will post a pic later.
|
Pirtek - that sound like a plan.
Clamps - really those are a better option? I am using a standard pipe clip you would use on a radiator pipe. Correctly sized obviously for the 7/8mm pipe on the fuel line.
VW Hertiage - I went looking there and didn't have any luck, some suggested Audi Hertiage. But struggled with them too..
I need these obviously "double sided barbed pipe joiners"
But no doubt there is a technical term I need to figure out
Thank you for all the replies.
J