Typ 44 disc problem
Hi everyone,
I'm damned if i know what's going on here! This is the story;
I have had the whole front suspension refreshed, new bushes, discs, pads, wheel bearings subframes powder coated the lot. Just buttoning everything back up and cannot get the front discs to sit on the hubs with the carriers over them. When i bolt up the carriers it's as if the hub is not spinning close enough to the hub carrier and so therefore the disc will not sit correctly - it is being pulled off centre by the postion of the carrier. The only thing i can think is the bearings aren't sitting in the hubs as they should. They are apparently correct 82mm dia by 37mm width stepped inside, the same as what came out. I'm scratching my head here! Do the bearing fit a certain way? Does anybody know how close the back of the hub should be to the carrier? Mine is approx 4mm away.
DERV
|