Forum: General Chat
15-03-24, 07:52 PM
|
Replies: 0
Views: 2,429
|
Forum: Gatherings and Events
20-02-24, 07:59 PM
|
Replies: 18
Views: 1,032
|
Forum: Gatherings and Events
16-02-24, 06:41 PM
|
Replies: 18
Views: 1,032
|
Forum: Gatherings and Events
06-02-24, 06:31 PM
|
Replies: 18
Views: 1,032
|
Forum: Gatherings and Events
05-02-24, 02:22 PM
|
Replies: 12
Views: 1,062
|
Forum: Gatherings and Events
25-01-24, 02:04 PM
|
Replies: 12
Views: 1,062
|
Forum: Gatherings and Events
22-01-24, 04:49 PM
|
Replies: 12
Views: 1,062
|
Forum: Gatherings and Events
20-01-24, 04:33 AM
|
Replies: 12
Views: 1,062
|
Forum: Gatherings and Events
18-01-24, 04:18 PM
|
Replies: 12
Views: 1,062
|
Forum: Gatherings and Events
18-01-24, 08:47 AM
|
Replies: 12
Views: 1,062
Central Scotland Meeting February 2024
Hi guys its been some time sine our last meeting, in the last 4 years we have lost some good friends and to be honest I did not think this day would come for us to meet up again, so, Elginhaugh Farm...
|
Forum: Engine
17-08-23, 03:32 PM
|
Replies: 4
Views: 791
Hi Guys, Removed the oil filter housing last...
Hi Guys, Removed the oil filter housing last night, removed the end plate with the four M6 bolts, the spring was intact and the piston did move freely, the piston is round with a large slot in the...
|
Forum: Suspension & Brakes
31-07-23, 05:48 PM
|
Replies: 25
Views: 4,415
Impact gun normally removes the 22mm top strut...
Impact gun normally removes the 22mm top strut nut without the aid of holding the strut center allen key, need to be carful with the slotted nut in the center of the top bearing mount, but by that...
|
Forum: Engine
31-07-23, 05:40 PM
|
Replies: 4
Views: 791
|
Forum: Engine
30-07-23, 04:05 PM
|
Replies: 4
Views: 791
WR Ur quattro, oil filter housing.
Hi Guys on the scrounge for information, my WR Ur quattro 1984 oil temp goes up very quickly and take for ever to come back down, when I was parking the car the other night, I went below the car to...
|
Forum: Parts For Sale
01-07-23, 08:04 PM
|
Replies: 3
Views: 1,294
|
Forum: Engine
14-06-23, 07:58 AM
|
Replies: 9
Views: 1,155
My B2 coupe Gt had a 2.2 KV engine, you can...
My B2 coupe Gt had a 2.2 KV engine, you can remove the front downpipe without removing the front drive shaft, my down pipe was a 2 into one style pipe, the 4 M10 nut you have to remove to remove the...
|
Forum: Engine
08-06-23, 05:37 PM
|
Replies: 6
Views: 1,038
|
Forum: Engine
06-06-23, 08:52 AM
|
Replies: 6
Views: 1,038
|
Forum: Engine
05-06-23, 09:58 AM
|
Replies: 6
Views: 1,038
WR engine Ur quattro odd noise
Hi guys, I have an odd bearing whine noise, but I know it is not bearing, please read on, when the engine is hot this odd whining noise comes and go's, I can get the noise to vanish when I open the...
|
Forum: General Chat
25-05-23, 04:04 PM
|
Replies: 8
Views: 2,444
Hi John, hope you are well, metering head...
Hi John, hope you are well, metering head rebuilt/sealed with loctite 574, applied with a very fine artist paint brush, loctite 574 dose set hard, as for rebuilding again in years to come could be...
|
Forum: General Chat
23-05-23, 08:21 PM
|
Replies: 8
Views: 2,444
|
Forum: Electrical problems
23-05-23, 07:21 PM
|
Replies: 8
Views: 1,054
Can only comment about WR engine, but from...
Can only comment about WR engine, but from memory, 3 pin plug on side of metering head base, ground, 12v supply and signal are the 3 wires, can't remember the order, with ohms meter connected across...
|
Forum: Bodywork, glass & exterior fitments
26-02-23, 03:51 PM
|
Replies: 14
Views: 4,479
I have had the same problem with my coupe Gt,...
I have had the same problem with my coupe Gt, thought it would be a case of getting new cheap door handle, (as the bit that fail is hard to replace), pop the lock/key barrel out of the original door...
|
Forum: Technical Info
25-02-23, 12:08 PM
|
Replies: 5
Views: 1,088
|
Forum: Technical Info
25-02-23, 05:34 AM
|
Replies: 5
Views: 1,088
Thanks vagdream, so this could be an easy fix,...
Thanks vagdream, so this could be an easy fix, like, bulb blown, or oil pressures switch faulty, or oil pressure relay / buzzer not working, do you have any working experience of the oil pressure...
|